伺服壓床簡易配方設定軟體操作說明
22
3.2.5 External I/O safety signal interrupt
1. The external [Safety Signal] was interrupted during the pressing. [X3]→OFF
2. The motor will stop immediately
3. After confirming the safety control components, trigger the [Safety Signal] again. [X3]→ON
4. Trigger the [Reset] signal. [X2]→ON
5. The machine will abandon this pressing action, and the motors will return the spindle to the working
origin and trigger the [Waiting] signal. [Y1]→ON
6. Stop triggering the [Reset] signal. [X2]→OFF
7. Restart the [Trigger] signal, and start the pressing process. [X1]→ON
To Next Page
Loading...
