Delta ECMA-C 0807 Series User Manual

Chapter 8 Parameters ASDA-A2
8-26 Revision February, 2017
Settings：
The using method is the same as P0-25. The mapping target is set by
parameter P0-36.
P0-27 MAP3 Mapping Parameter # 3
Address: 0036H
0037H
Operational
Interface：
Panel / Software Communication
Related Section:
4.3.5
Default：
No need to initialize
Control
Mode：
ALL
Unit：
-
Range：
determined by the corresponding parameter
of P0-37
Data Size：
32-bit
Format：
Hexadecimal
Settings：
The using method is the same as P0-25. The mapping target is set by
parameter P0-37.
P0-28 MAP4 Mapping Parameter # 4
Address: 0038H
0039H
Operational
Interface：
Panel / Software Communication
Related Section:
4.3.5
Default：
No need to initialize
Control
Mode：
ALL
Unit：
-
Range：
determined by the corresponding parameter
of P0-38
Data Size：
32-bit
Format：
Hexadecimal
Settings：
The using method is the same as P0-25. The mapping target is set by
parameter P0-38.

Delta ECMA-C 0807 Series Specifications

General

Brand	Delta
Model	ECMA-C 0807 Series
Category	Servo Drives
Language	English