BMS Communication wiring
The PCS100HV can be connected to BMS by Ethernet or CAN.
1. If the PCS100HV is connected to BMS by Ethernet, a switcher should be used as shown in Fig.29.
and the BMS communication wire, PCS communication wire and EMS connmunication wire should be
connected to the same Ethernet switcher.
2. If the PCS100HV is connected to BMS by CAN, the connector CNS10 should be connected as shown
in Fig. 30 and Table 12. And the terminal resistors SWS5 should be settled to the “ON” site.
To Next Page
Loading...
