DC Wiring
1.
Prepare DC cables: Prepare several 1/0 sizes, 1500V cables for DC wiring. The PCS
supports up to 2 sets of battery connection, and each set of battery connection requires two
cables (one for positive, the other for negative). Connect the DC cables to the two-hole lugs
which are available, and use heat shrinkable tubing on the junction between the cables and
lugs to prevent the exposure of the conductive part.
2.
Remove the protective cover of DC terminals: Remove the protective cover in front of the
DC terminals as shown in the following figure. There are two labels indicating the polarity of
the terminals: “DC+” for positive, and “DC-“ for negative.
To Next Page
Loading...
