Need help?Do you have a question about the Delta RPI-H5 and is the answer not in the manual?
Provides detailed information on specifications, installation, and settings for RPI-H3/RPI-H5 models.
Explains safety symbols and provides essential instructions for safe operation and handling of the inverter.
Outlines the models covered by the manual and their validity for installation procedures and technical data.
Strongly recommends reading the manual thoroughly before installation for safety and proper procedures.
Illustrates the step-by-step process of unpacking the RPI-H3 and RPI-H5 inverter units.
Provides detailed dimensional drawings and measurements for both RPI-H3 and RPI-H5 inverter models.
Provides critical safety warnings and guidelines for selecting a suitable and safe installation location for the inverter.
Describes the wall-mounting system, ensuring perpendicular installation, and the process of attaching the mounting plate.
Covers essential pre-wiring checks, including voltage, polarity, grounding, and system wiring diagrams.
Details the RS-485 pin definition and references tables for protocol settings and multi-inverter connections.
Covers settings for active power control, including power limit and frequency-dependent power reduction.
Allows users to reduce inverter output power by setting a percentage of actual or rated power.
Explains how active power is adjusted based on grid frequency variations according to specific standards.
Details the requirements and methods for controlling reactive power output, including fixed power factor and voltage characteristics.
Explains the LVRT requirements for generation systems over 6 kW to avoid disconnection during grid voltage dips.
Outlines the critical steps for safely starting up the PV inverter, including voltage checks and initial setup.
Details how to measure the open circuit DC voltage of the PV array before inverter startup.
Explains how to check the AC utility voltage to ensure it is within the inverter's operating range.
Describes the final steps for switching on the inverter and navigating the initial setup screens.
Guides users through the process of selecting their country for proper inverter configuration and operation.
Explains the various measurements displayed by the inverter, such as output, voltage, current, and energy.
Lists detailed technical specifications for RPI-H3 and RPI-H5 models, covering general, DC input, and AC output parameters.
To Next Page
General
