Delta RPI-H5

7.2.2 AC Configuration Setting
1. Turn on DC power and wait for the LCD display is ready, then press “SEL” button
until “Country XXX" is displayed.
2. Press and hold both “SEL” and “ENT” buttons for 10 seconds until “Language
XXXXXX” is shown.
3. Press “SEL” until “AC Configurat. XXXXXX” is shown.
4. Press “ENT” to enter AC Configuration Setting page, press “SEL” to flip between two
types of configuration. As your type of configurations is displayed, press ”ENT” to
confirm the setting.
DSP Comm. Red.
0000 0000 0000
Event List
Enter
Inverter
ID : XX
Country
XXX
Language
XXX
Insulation Mode
XXX
SEL
SEL
SEL
SEL
SEL
SEL
Event List Start
ENT
RS485 ID Setting
Start
SEL + ENT
> 3 sec.
Install Settings
Start
SEL + ENT
> 10 sec.
System
Information
xxxxxx
xxxxxx
Inverter
5.0kVA
Figure 7-2 : AC Configuration Setting-1
36
Turn PV inverter on/off