Delta VFD-ED Series User Manual

Chapter 9 Digital KeypadVFD-ED
9-23
File Copy Setting Fault Description
These faults occur when KPC-CC01 cannot perform the command after pressing the ENTER key in
the copy function.
LCD Display Fault Name Description Corrective Actions
Read only (ERR1)
Parameter and file are
read-only
The parameter / file is read-only and
cannot be written to.
1. Verify the specification in the user
manual.
If this solution does not work, contact your
local authorized dealer for assistance.
Write in error
(ERR2)
Fail to write parameter and
file
An error occurred while writing to a
parameter / file.
1. Check for any problem on the Flash IC.
2. Shut down the system, wait for ten
minutes, and then restart the system.
If none of the above solutions works,
contact your local authorized dealer for
assistance.
Drive operating
(ERR3)
AC motor drive is in
operating status
A setting cannot be changed while the
motor drive is in operation.
1. Verify that the drive is not in operation.
If this solution does not work, contact your
local authorized dealer for assistance.
Parameter locked
(ERR4)
AC motor drive parameter
is locked
A setting cannot be changed because a
parameter is locked.
1. Check if the parameter is locked. If it is
locked, unlock it and try to set the
parameter again.
If this solution does not work, contact your
local authorized dealer for assistance.
Parameter
changing (ERR5)
AC motor drive parameter
is changing
A setting cannot be changed because a
parameter is being modified.
1. Check if the parameter is being
modified. If it is not being modified, try
to change that parameter again.
If this solution does not work, contact your
local authorized dealer for assistance.
Fault code
(ERR6)
Fault code is not cleared
A setting cannot be changed because an
error has occurred in the motor drive.
1. Check if any error occurred in the motor
drive. If there is no error, try to change
the setting again.
If this solution does not work, contact your
local authorized dealer for assistance.
Warning code
(ERR7)
Warning code is not
cleared
A setting cannot be changed because of a
warning message given to the motor drive.
1. Check if there is a warning message
given to the motor drive.
If this solution does not work, contact your
local authorized dealer for assistance.

Delta VFD-ED Series Specifications

General

Brand	Delta
Model	VFD-ED Series
Category	DC Drives
Language	English