Chapter 9 Digital KeypadVFD-ED
A. Refer Device: specifies the VFD communication port.
B. Direction Setting: specifies the direction: From Bottom to Top, From Top to Bottom, From Left
to Right or From Right to Left.
C. Value Length: determines the range of the maximum value and minimum value.
D. Max Value and Min Value: specifies the maximum value and minimum value. A value smaller than
or equal to the minimum value causes the bar graph to be blank (0). A value is bigger or equal to the
maximum value causes the bar graph is full (100%). A value between the minimum and maximum
values causes the bar graph to be filled proportionally.
(6) Button : on the toolbar, click . Currently this function only allows the keypad to switch pages; other
functions are not yet available (including text input and insert image). In the blank page, double-click
to open the Button Setting dialog box.
Button Type: specifies the button’s functions.
Page Jump and Constant Setting are the only functions currently supported.
A. Page Jump Setting
a. Page Jump Setting: in the Button Type list, choose Page Jump to show the Page Jump
Setting.
b. Function Key: specifies the functions for the following keys on the KPC-CC01 keypad: F1, F2, F3,
F4, Up, Down, Left and Right. Note that the Up and Down keys are locked by TPEditor. You
cannot program these two keys. If you want to program Up and Down keys, on the Tool menu,
click Function Key Setting, and then click Re-Define Up/Down Key.
c. Button Text: specifies the text that appears on a button. For example, when you enter Next Page
for the button text, that text appears on the button.
To Next Page
Loading...
Need help?
General