Delta VFD-ED Series

Chapter 11 Summary of Parameter Settings | VFD-ED
11-23
Pr. Parameter Name Setting Range Default
VF
VFPG
SVC
FOCPG
FOCPM
Power-on Time at the
Sixth Fault (min.)
only
06-43
Accumulated Drive
Power-on Time at the
Sixth Fault (day)
0–65535
Read
only
○ ○ ○ ○
06-44
(EPS) Emergency Power
Mode Operation Speed
0.00–299.00 Hz
Read
only
○ ○ ○ ○ ○
 06-45
Fault and Warning
Actions
Bit0 = 0: Display Lv fault and coast to
stop
Bit0 = 1: Display Lv warn and coast to
stop
Bit1 = 0: Fan lock, fault and coast to stop
Bit1 = 1: Fan lock, warn and continue
operation
Bit2 = 0: software GFF protection
enabled
Bit2 = 1: software GFF protection
disabled
0 ○ ○ ○ ○ ○
 06-46
(EPS) Emergency Power
ON Operation Direction
0: Run according to the current
command
1: Run according to the operation
direction of power generation mode,
and execute the power generation
direction detection when in power
generation mode.
2: After determining the power
generation direction, the host
controller sends a running direction
command. (When at STOP, the
direction of power generation mode
(MO = 32) confirms and the direction
of power generation mode does not
remain.)
Execute the power generation
direction detection every time.
3. After determining the power
generation direction, the host
controller sends a running direction
command. (When at STOP, the
direction of power generation mode
(MO =32) confirms and the direction of
power generation mode remains.)
Execute the power generation
direction detection one time.
4. Run according to the operation
direction of power generation mode,
and execute the power generation
0 ○ ○ ○ ○ ○