Deltronic Security TT-2000 Ticket Eater - Performing Functions Without Software

TT-2000 Ticket Eater™ by Deltronic Labs February 2013
11
Performing Functions Without Software
DL Ticket Eater Manager software is the preferred way to manage your TT-2000 Ticket
Eater with AP-100 main logic board. A previous section of this manual covers the
software. Some management functions can also be done without the software by a
special Function mode. This mode uses buttons inside the TT-2000. This section covers
the Function mode.
These procedures use the two buttons mounted in front of the logic board, the SW1
button on the logic board, and the 7 segment display on the door. To enter the Function
mode:
1. Open the top door of the Ticket Eater.
2. While pressing SW1, pull out the safety switch. This turns the Ticket Eater on
with the door open and starts the Function mode.
3. The display will show FUNC0.
4. Use the black and red buttons to change the function number.
5. Press SW1 to select the function.
Button
Function
Black
Increase the function number
Red
Decrease the function number
SW1
Select the function
Function
Action
0
Exit the function mode
1
Print a duplicate receipt
2
Print an audit report
3
Reset the bucket meter
4
Print an options report