DEMA D6B Series - 6.6 Protection function parameters

NO.6 Detailed Function Description
52
selection for first 8 segments
P085
╳
Acceleration/deceleration time
selection for last 8 segments
This parameter set is only effective when P080 is set as 1. The setting methods of
acceleration/deceleration time for internally controlled multi-stage speed and segment speed
are as follows:
(1) Acceleration/deceleration time is determined by binary 2bit
Bit1
Bit0
Acceleration/deceleration time
0
0
First acceleration/deceleration time P014, P015
0
1
Second acceleration/deceleration time P016, P017
1
0
Third acceleration/deceleration time P018, P019
1
1
Fourth acceleration/deceleration time P020, P021
(2) Acceleration/deceleration time for each segment is determined by binary 16bit
Eighth
segmen
t speed
Sevent
h
segmen
t speed
Sixth
segmen
t speed
Fifth
segmen
t speed
Fourth
segmen
t speed
Third
segmen
t speed
Second
segmen
t speed
First
segmen
t speed
t8
t7
t6
t5
t4
t3
t2
t1
0
0
0
0
0
0
0
0
0
1
1
0
0
0
1
1
t1 acceleration/deceleration time IV
t2 acceleration/deceleration time I
t3 acceleration/deceleration time III set value
t4 acceleration/deceleration time II
t5 acceleration/deceleration time I P084 is set as 99
t6 acceleration/deceleration time I Attached:
t7 acceleration/deceleration time I
t8 acceleration/deceleration time I