Denon AVR-1404 - Page 22

ENGLISH
DENON and other makes of components can be operated by setting the preset memory.
This
remote
contro!
unit
can
be
used
to-operate
components
of
other
manufacturers
without
using
the
learning
function
by
registering
the
manufacturer
of
the
component
as
shown
on
the
List of
Preset
Codes (pages
98~102).
Operation is not possible for some models.
1 Set mode switch 1 to “AUDIO” or “VIDEO”.
AUDIO e——————_-
e VIDEO—
im ma
Set the AUDIO side for the CD, Tape deck or CDR/MD
position, to the VIDEO side for the DVD/VDP, DBS/CABLE,
VCR or TV position.
2 Set mode switch 2 to the component to be registered.
COR/MD4 pTAPE
DVD/VDP—e TV
ver! Toss /caBLe
ia mn
Press the ON/SOURCE button and the OFF button at the
3 same time.
OFF ON/SOURCE
¢ Indicator flash.
Referring to the included List of
Preset Codes, use the number
buttons to input the preset code (a
3-digit number) for the
®
© ©
‘) Nat manufacturer of the component
whose signals you want to store in
the memory.
To store the codes of another component in the memory,
repeat steps 1 to 4.
NOTES:
¢
The
signals
for
the
pressed
buttons
are
emitted
while
setting
the
preset
memory.
To
avoid
accidental
operation,
cover
the
remote
control
unit's
transmitting
window
while
setting
the
preset
memory.
:
¢
Depending
on
the
model
and
year
of
manufacture,
this
function
cannot
be
used
for
some
models,
even
if
they
are
of
makes
listed
on
the
included
list
of
preset codes.
¢
Some
manufacturers
use
more
than
one
type
of
remote
control
code.
Refer
to
the
included
list
of
preset
codes
to
change
the
number
and
check.
¢
The
preset
memory
can
be
set
for
one
component
only
among
the
following:
CDR/MD,
DVD/VDP
and
DBS/CABLE.
|
The preset codes are as follows upon shipment from the factory and after resetting:
....DENON
ass ate rynsneateses Deuter ioe DENON (CDR)
Hisiciaie Geisseabdtesesetes DENON (DVD)
scoulcash sosebitaipecclectwesetea cates ches ABC (CABLE)
22