Denon AVR-1404 Operating Instructions

ENGLISH
Playing the input source
1 Select the input source to be played.
Example: CD
INPUT SELECTOR cb
(Main unit) (Remote control unit)
2 Select the input mode.
¢ Selecting the analog mode
Press the ANALOG button to switch to the analog input.
ANALOG
(Main unit) (Remote control unit)
¢ Selecting the external input (EXT. IN) mode
Press the EXT. IN (or the EXT. IN button on the remote
control unit) to switch the external input.
EXT. IN
aN
(Main unit)
¢ Selecting the AUTO, PCM and DTS modes
The mode switches as shown below each time the INPUT
MODE button is pressed.
(Remote control unit)
AUTO—* PCM —~ DTS
INPUT MODE
a
(Main unit)
(Remote control unit)
Input mode selection function
Different input modes can be selected for the different input sources.
The selected input modes for the separate input sources are stored
in the memory.
@ AUTO (All auto mode)
In this mode, the types of signals being input to the digital and
analog input jacks for the selected input source are detected and
the program in the this unit’s surround decoder is selected
automatically upon playback. This mode can be selected for all
input sources other than TUNER.
The presence or absence of digital signals is detected, the signals
input to the digital input jacks are identified and decoding and
playback are performed automatically in DTS, Dolby Digital or
PCM (2 channel stereo) format. If no digital signal is being input,
the analog input jacks are selected.
Use this mode to play Dolby Digital signals.
@ PCM (exclusive PCM signal playback mode)
Decoding and playback are only performed when PCM signals are
being input.
Note that noise may be generated when using this mode to play
signals other than PCM signals.
® DTS (exclusive DTS signal playback mode)
Decoding and playback are only performed when DTS signals are
being input.
@ ANALOG (exclusive analog audio signal playback mode)
The signals input to the analog input jacks are decoded and
played.
® EXT. IN (external decoder input jack selection mode)
The signals being input to the external decoder input jacks are
played without passing through the surround circuitry.
NOTE:
¢ Note that noise will be output when CDs or LDs recorded in DTS
format are played in the “PCM” (exclusive PCM signal playback) or
“ANALOG” (exclusive analog audio signal playback) mode. Select
the AUTO or DTS (exclusive DTS signal playback) mode when
playing signals recorded in DTS from a laser disc player.
Notes on playing a source encoded with DTS
¢ Noise may be generated at the beginning of playback and
while searching during DTS playback in the AUTO mode. If
so, play in the DTS mode.
¢ In some rare cases the noise may. be generated when you
preform the operation to stop playback of a DTS-CD or DTS-LD.

Denon AVR-1404 Specifications

General

Brand	Denon
Model	AVR-1404
Category	Stereo Receiver
Language	English