El
12 OPERATION
Preparations:
Check that all connectrons are proper.
1
Turn on the power.
Press the ON/STANDBY button on the main unit or
ON/SOURCE button on the remote control unit to turn on the
power.
(Mm umtl
(Remote control uvtl
l ON/STANDBY
When the button is pressed, the power turns on and the
drsplay lights after approximately 1 second.
When pressed again, the power turns off, the standby
mode is set and the display turns off.
Several seconds are required from the time the power
operation switch is set to the “ON” position until sound is
output. This is due to the built-in muting circuit that
prevents noise when the power switch is turned on and off.
Select the front speakers.
Press the SPEAKER A or B button to turn the speaker on
(Man unit)
(Remote control unit)
l The front speaker A, B setting can be also be changed with
the SPEAKER button on the remote control unit.
29
To Next Page
Loading...
