22
ENGLISH
2
Select the STANDARD (Dolby Pro Logic IIx)
mode.
(Main unit) (Remote control unit)
• The Dolby Pro Logic II indicator lights.
Display
Light
3
Play a program source with the
mark.
• For operating instructions, refer to the manuals
of the respective components.
Dolby Pro Logic
II
x (Pro Logic
II)
mode
1
Select the function to which the component you
want to play is connected.
Example: DVD
The Dolby Surround Pro
Logic
IIx Cinema or Music
mode can be chosen
directly by pressing the
CINEMA or MUSIC button
on the remote control unit
during playback in the
Dolby Surround Pro Logic
IIx mode.
(Main unit) (Remote control unit)
4
Select the surround parameter mode.
Display
To perform this operation from the remote
control unit, check that the mode selector
switch is set to “AUDIO”.
(Main unit) (Remote control unit)
To play in the PL IIx mode, set “S. BACK” at the Speaker Configuration setting to “SMALL” or “LARGE”.
• After adjusting using the test tones, adjust the channel levels either according to the playback sources or to
suit your tastes, as (described) below.
1
Select the speaker whose level you want to
adjust.
2
The channel switches as shown below each
time the button is pressed.
(Remote control unit)
Default setting of channel level is 0 dB.
The level of the selected speaker can be
adjusted within the range of +12 to –12 dB
using cursor buttons.
SW channel level can be turned off by
decreasing one step from –12 dB.
OFF ´ –12 dB ´ 12 dB
(Remote control unit)
NOTE:
• Please make sure the “AUDIO” position of
the slide switch on the remote control unit.
3
Adjust the level of the selected speaker.
(Remote control unit)
To Next Page
Loading...
Need help?
General
Weight and Dimensions
