Denon AVR-1705 Operating Instructions

25
ENGLISH
5
Set the surround parameter according to the
source.
(Remote control unit)
NOTE:
•Please make sure the “AUDIO” position of
the slide switch on the remote control unit.
(Main unit)
• The mode switches as shown below each
time the button is pressed.
CINEMA EQ
TONE DEFEAT
SURROUND BACK
DEFAULT
D.COMP.
LFE
If you do want the bass and trable to be
adjusted, turn off the tone defeat mode.
6
Set the various surround parameters.
• CINEMA EQ setting
ON OFF
or
or
CINEMA EQ OFF
• D. COMP. setting
OFF
LOW MID HIGH
oror
D.COMP. OFF
NOTE:
• This parameter is displayed during DOLBY
DIGITAL playback.
• LFE setting
-10dB
-5dB 0dB
oror
LFE 0dB
• TONE DEFEAT setting
ON OFF
or
or
TONE DEF. ON
• SURROUND BACK SPEAKER setting
MTRX ON
NON MTRX OFF
oror
SB : MTRX ON
NOTE:
• This parameter is displayed during DOLBY
DIGITAL playback.
• DEFAULT setting
YES NO
or
or
DEFAULT Y/N
Select “Yes” to reset to the factory defaults.
7
Press the ENTER button to finish surround
parameter mode.
(Remote control unit)
NOTE:
• When making parameter settings, the display
will return to the regular condition several
seconds after the last button was pressed and
the setting will be completed.
Dolby Digital mode (only with digital input) and DTS Surround (only with digital input)
2 5 63
1 1 4
5
3
66
1
1
7
2
Playback with a digital input
1
Select the input source.
q Select an input source set to digital
(COAXIAL/OPTICAL) (see page 15).
Example: DVD
w Set the input mode to “AUTO” or DTS.
(Main unit) (Remote control unit)
(Main unit) (Remote control unit)
2
Select the STANDARD (Dolby/DTS Surround)
mode.
(Main unit) (Remote control unit)
4
Play a program source with the ,
mark.
DIGITAL
• The DTS indicator lights when
playing DTS sources.
Light
• The Dolby Digital indicator lights
when playing Dolby Digital
sources.
Light
Operate the SURROUND BACK button to
switch Surround Back CH ON/OFF.
(Main unit) (Remote control unit)
• Lights when the Surround
Back CH is on.
Light
3

Denon AVR-1705 Specifications

General

Speakers connectivity type	-
Receiver type	Surround
Frequency range	10 - 100000 Hz
Audio output channels	6.1 channels
Signal-to-Noise Ratio (SNR)	98 dB
Power output per channel (1KHz@6 Ohm)	110 W
Power output per channel (20-20KHz@8 Ohm)	75 W
Product color	Black
Audio decoders	DTS, DTS 96/24, DTS Neo:6, DTS-ES (Discrete 6.1), DTS-ES (Matrix 6.1), Dolby Digital, Dolby Digital EX
Digital Signal Processing (DSP)	Yes
AM band range	520 - 1710 kHz
FM band range	87.5 - 107.9 MHz
Supported radio bands	AM, FM
Preset stations quantity	56
AC input voltage	230 V
AC input frequency	50 Hz
Power consumption (typical)	230 W
Optical drive included	No
HDMI in	0
Composite video in	4
S-Video inputs quantity	3
Digital audio optical in	1
S-Video outputs quantity	2

Weight and Dimensions

Depth	417 mm
Width	434 mm
Height	147 mm
Weight	10900 g