30
ENGLISH
Preset stations
Preparations:
Use the “Auto tuning” or “Manual tuning” operation
to tune in the station to be preset in the memory.
1
Press the MEMORY button.
2
Press the SHIFT button and select the desired
memory block (A to G).
4
Press the MEMORY button again to store the
station in the preset memory.
To preset other channels, repeat steps 1 to 4.
A total of 56 broadcast stations can be preset – 8
stations (channels 1 to 8) in each of blocks A to G.
3
Press the PRESET • (+) or ª (–) button to
select the desired preset channel (1 to 8).
NOTE:
•Please make sure the “AUDIO” position of
the slide switch on the remote control unit.
3
Press the MODE button to set the auto tuning
mode.
4
Press the TUNING • (+) or ª (–) button.
• Automatic searching begins, then stops
when a station is tuned in.
Lit
NOTE:
• When in the auto tuning mode on the FM band, the
“STEREO” indicator lights on the display when a
stereo broadcast is tuned in. At open frequencies,
the noise is muted and the “TUNED” and
“STEREO” indicators turn off.
Manual tuning
1
Set the input function to “TUNER”.
3
Press the MODE button to set the manual
tuning mode.
Check that the display’s “AUTO” indicator
turns off.
4
Press the TUNING • (+) or ª (–) button to tune
in the desired station.
The frequency changes continuously when the
button is held in.
2
Watching the display, press the BAND button
to select the desired band (AM or FM).
NOTE:
• When the manual tuning mode is set, FM stereo broadcasts are received in monaural and the “STEREO”
indicator turns off.
1
Set the input source to “TUNER”.
2
Watching the display, press the BAND button
to select the desired band (AM or FM).
(Main unit) (Remote control unit)
(Main unit) (Remote control unit)
(Remote control unit)
(Main unit) (Remote control unit)
To Next Page
Loading...
Need help?
General
Weight and Dimensions
