42
ENGLISH
Adjusting the volume
Use VOL df to adjust the volume.
GAdjustable rangeH
– – –
–80dB – –40dB – 18dB
(When the “Volume Display” (vpage62) setting is “Relative”)
GAdjustable rangeH
0 – 41 – 99
(When the “Volume Display” (vpage62) setting is “Absolute”)
• At time of purchase, “Volume Limit” (vpage62) is set to “–10dB
(71)”.
Turn MASTER VOLUME after pressing ZONE2/REC SELECT on the
main unit to adjust the sound volume.
Turning off the sound temporarily
Press MUTE.
The sound is reduced to the level set at “Mute Level” (vpage62) in
the menu.
• To cancel, either adjust the volume or press
MUTE again.
• The setting is canceled when the zone’s power is turned off.
Playback
1
6ZLWFK
ZONE SELECT
WR³=21(´
The remote control unit switches to the
operating mode for ZONE2.
Input source
select buttons
2
3UHVVAMP
3
3UHVV ZONE/DEVICE ON WR WXUQ
RQWKH=21(SRZHU
The indicator on the display lights.
• Also, pressing any of input source select
button in standby mode turns on the power.
• When
ZONE/DEVICE OFF is pressed, ZONE2
turns off.
• Power in ZONE2 can be turned on or off by
pressing
ZONE2 ON/OFF on the main unit.
4
3UHVVWKHLQSXWVRXUFHVHOHFWEXWWRQ
The audio signal of the selected source is output to ZONE2.
• Turn
SOURCE SELECT after
pressing
ZONE2 / REC SELECT
on the main unit to select an
input source.
When power for both MAIN ZONE and ZONE2 is set to ON, power of
the MAIN ZONE only can be turned off. Select “MAIN” in step 1 then
press
ZONE/DEVICE OFF.
Quick select function
It is also possible to save three settings for ZONE2.
n Saving the settings
1
6HWWKHLWHPVEHORZWRWKHVHWWLQJV
\RXZDQWWRVDYH
q Input source (vpage42)
w Volume (vpage42)
2
6ZLWFK ZONE SELECT WR
³=21(´
The remote control unit switches to the
operating mode for ZONE2.
3
3UHVVDQGKROGWKHGHVLUHGQUICK SELECTEXWWRQXQWLO
³0HPRU\´DSSHDUVRQWKHGLVSOD\
The current settings will be memorized.
GQuick select defaultsH
Input source Volume
QUICK SELECT 1 BD –40dB
QUICK SELECT 2 SAT/CBL –40dB
QUICK SELECT 3 DOCK –40dB
n Recalling the settings
1
6ZLWFK ZONE SELECT WR
³=21(´
The remote control unit switches to the
operating mode for ZONE2.
2
3UHVVQUICK SELECTDWZKLFKWKH
VHWWLQJV \RX ZDQW WR FDOO RXW DUH
VDYHG
Naming quick select settings
See “Quick Select Name” (vpage63).