Denon AVR-2807 User Manual

34
Basic Operation Basic Operation
Press ENTER.
Press ENTER or SURROUND PARAMETER.
Press
GG
to select “OFF”.
Press
DD HH
to select “Bass” or “Treble”, then press
FF GG
to set the level.
Can be adjusted within the range of –6 dB to +6 dB.
3
4
5
6
1
2
2 When you do not want to adjust the tone
Either press
<
TONE DEFEAT
>
or set “Tone Defeat”
to “ON” at step 3 in “Adjusting the tone”.
3
Adjusting the speaker volume
Press CH SEL/ENTER.
Press
DD HH
or CH SEL/ENTER to select the
speaker.
The settable speaker switches each time this button is
pressed.
Press
FF GG
to adjust the volume.
Can be adjusted within the range of –12 dB to +12 dB.
1
2
3
“SB” when surround back
speaker set to “1spkr”.
Not displayed when
“None” set.
Setting the tone control
Adjust the bass and treble to suit your tastes.
Press SURROUND PARAMETER.
Press
DD HH
to select “TONE”, then press
FF
.
In the direct mode, “TONE” cannot be selected.
2 Adjusting the tone
1
2
About the button names in this explanation
<>: Buttons on the main unit
[]: Buttons on the remote control unit
Button name only :
Buttons on the main unit and remote control unit
D H F G
<TONE DEFEAT>
SURROUND
PARAMETER
CH SEL/
ENTER
<FUNCTION>
SURROUND
PARAMETER
CH SEL/ENTER
D
H F G
[SHIFT]
[BAND]
[MODE]
[MEMORY]
[TUNER]
[TUNING]
[CHANNEL]

Denon AVR-2807 Specifications

General

Number of Channels	7.1
HDMI Inputs	2
HDMI Outputs	1
Component Video Inputs	3
Component Video Outputs	1
Dolby Digital	Yes
DTS	Yes
Frequency Response	10 Hz - 100 kHz (+1, -3 dB)
Total Harmonic Distortion	0.05%
Input Sensitivity	200 mV
Signal-to-Noise Ratio	100 dB
Speaker Impedance	6-16 ohms
Tuner Type	AM/FM
Power Output	110W per channel
Digital Audio Inputs	2 coaxial
Auto Setup	Audyssey MultEQ
Multi-room	Yes
Width	434 mm
Height	171 mm
Dimensions	434 x 171 x 414 mm