65
Setting the punch through function
CD, CDR/MD, TAPE, DVD/VDP or VCR mode buttons can be
assigned to unused TV and DBS/CABLE mode buttons.
For example, when CD mode operations are assigned to TV
mode buttons, the CD mode can be operated while in the TV
mode ( []).
Press [ON/SOURCE] and [POWER OFF] at the
same time.
• The “LEARNED/TX” indicator blinks.
Press [1].
• [MODE SELECTOR] (TV and DBS/CABLE) and the
“LEARNED/ TX” indicator blinks.
Press [MODE SELECTOR] for which punch
through is to be set (TV or DBS/CABLE).
• [MODE SELECTOR] (CD, CDR/MD, TAPE, DVD/VDP or VCR)
and the “LEARNED/TX” indicator blinks.
Press [MODE SELECTOR] for the device to be
punched through (CD, CDR/MD, TAPE, DVD/
VDP or VCR).
• [MODE SELECTOR] that was set will lights.
1
2
3
4
Resetting the remote control unit
Resetting the learning function
Press [USE/LEARN] with the tip of a pen etc., to
set the learn mode.
• [MODE SELECTOR] and the “LEARNED/TX” indicator blinks.
1
Press [MODE SELECTOR] for the device to be
reset.
• [MODE SELECTOR] and the “LEARNED/TX” indicator blinks.
2
Hold for 4 seconds or longer [MODE SELECTOR]
of the equipment that is to be reset and
[ON/SOURCE].
• [MODE SELECTOR] and the“LEARNED/TX” indicator blinks
again.
3
Press [USE/LEARN].
4
Resetting the punch through setting
Press [ON/SOURCE] and [POWER OFF] at the
same time.
• The “LEARNED/TX” indicator blinks.
1
Press [1].
• [MODE SELECTOR] (TV or DBS/CABLE) and the “LEARNED/
TX” indicator blinks.
2
Press [MODE SELECTOR] (TV or DBS/CABLE)
that is to be reset.
• [MODE SELECTOR] (CD, CDR/MD, TAPE, DVD/VDP or VCR)
and the “LEARNED/TX” indicator blinks.
3
Press [MODE SELECTOR] of the equipment that is
to be reset again.
4
Operating the remote control unit Operating the remote control unit
To Next Page
Loading...
