85
13
LISTENING TO THE RADIO
If tuning does not stop at the desired station, use to the “Manual
tuning” operation.
1
Set the input function to “TUNER”.
2
Watching the display, press the
BAND button to select the desired
band (AM or FM).
3
Press the MODE button to set the
auto tuning mode.
4
Press the TUNING + or – button.
Auto tuning
“Auto” appears on the display.
Automatic searching begins, then
stops when a station is tuned in.
(Main unit)(Remote control unit)
Manual tuning
1
Set the input function to “TUNER”.
(Remote control unit)
(Remote control unit)
(Remote control unit)
• Check that the remote control unit is set to AMP or TUNER.
2
Watching the display, press the
BAND button to select the desired
band (AM or FM).
3
Press the MODE button to set the
manual tuning mode.
Check that the display’s “AUTO”
indicator turns off.
(Main unit)(Remote control unit)
(Remote control unit)
(Remote control unit)
4
Press the TUNING + or – button to tune
in the desired station.
The frequency changes continuously
when the button is held in.
(Remote control unit)
NOTES:
• When in the auto tuning mode on the FM band, the “STEREO”
indicator lights on the display when a stereo broadcast is tuned in.
At open frequencies, the noise is muted and the “TUNED” and
“STEREO” indicators turn off.
• When the manual tuning mode is set, FM stereo broadcasts are
received in monaural and the “STEREO” indicator turns off.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
