29
Setting the Multi Zone Control
Multi-zone is a pre-output with an output level adjustment function.
Using the power amplifier assignment function described below, it is also possible to connect speakers to the SB/MULTI speaker terminals.
Make this setting to switch the power amplifier for the surround back channel to Multi-zone.
[1] Power amplifier assignment function setting
1
At the System Setup Menu, select “Multi Zone Control”.
2
Press the “ENTER” button to switch to the “Multi Zone Control” screen.
3
Select “Power Amp Assignment” then press the “ENTER” button.
1
At the System Setup Menu, select “Multi Zone Control”.
[2] Setting the multi-zone level
4
Select “Surround Back” to use as the surround back
channel, “Multi” to use as multi-zone, then press the
“ENTER” button.
When “Surround Back” is selected When “Multi” is selected
To Next Page
Loading...
