Denon AVR-4802R - Setting the Back Lights Lighting Time

41
Resetting
Setting the back light’s lighting time
DVD
2, 3
11
2, 3
1
2
Press the power ON/SOURCE button and the OFF button at
the same time.
• “PRE” appears on the remote control unit’s display.
Use the • and ª cursor buttons to display “BKLT” on the
remote control unit, then press the ENTER button.
• “05SEC” appears on the remote control unit’s display.
3
Use the • and ª cursor buttons to adjust the lighting time (3
sec ~ 30 sec), then press the ENTER button.
• “OK” is displayed and that lighting time is set.
(1) Resetting the preset memory
DVD
2, 3, 4
11
2, 3, 5
1
2
Press the power ON/SOURCE button and the OFF button at
the same time.
•“PRE” appears on the remote control unit’s display.
Use the • and ª cursor buttons to display “RST” on the
remote control unit, then press the ENTER button.