55
[2] When using the SB/MULTI speaker terminals
Settings can be made at the system setup menu so that the same source as the MULTI ZONE pre-out terminals can be played from the
speakers connected to the MULTI speaker terminals.
NOTE:
When the main unit is set to the recording output mode, remote control unit keys indicated “MULTI” mode cannot be operated. (See page
53.)
Room to Room Remote Control jacks
• The OUT jack is an extension jack for future use.
• When the OUT jack is connected, the signals input to the IN jack are output from the OUT jack directly. (Example: RC616 signals are output.)
• Do not connect only the OUT jack.
(The signals from the AVR-4802R’s remote sensor are not output to this jack.)
To Next Page
Loading...
