Settheoperationforthedigitalsignalswhenplayinginthe6.1SURROUNDandDTS-ESsurroundmodes.
1
At the System Setup Menu select "SB CH Auto Flag
Detect" and press the ENTER button.
System Setup Menu
Speaker Configuration
_SB CH Auto Flag Detect
Delay Time
Channel Level
Digital In Assisnment
On Screen Display
Auto Tuner Presets
Select the desired setting.
We recommend setting this to
"OFF".
When set to "ON", then set the
operation for software for which
no identification signals are
recorded {Non-Flag Source).
_DTS-ES/6. 1Sour ce
Auto Flag Detect Mode
"_DTS-ES/6. 1Source
Auto Flag Detect Mode
Non-Flag Source
SBch Output
NON- OFF
MTRX
Setting
_ Auto Flag Detect Mode (AFDM)
ON: This function only works for sources containing DTS-ES or 6.1-channel surround identification signals.
When this function is used, sources that have been recorded in 6.1-channel surround or DTS-ES are automatically played in the 6.1-
channel surround mode using the surround back speaker{s). (Refer to _2_for the method of playback of the surround back speaker in
this case.)
OFF: Set this mode if you wish to play normal 5.1-channel sources or sources not containing the identification signals in the 6.1-channel
mode.
_2_Non-Flag Source SBch Output
MTRX ON: Sources are played using the surround back speaker(s). The surround back channel is played with digital matrix processing.
NON-MTRX: Sources are played using the surround back speaker{s). The same signals as those of the surround channel are output from
the surround back speaker(s).
OFF: Sources are played without using the surround back speaker(s).
_ Enter the setting.
The System Setup Menu reappears.
NOTES:
• The SB CH Auto Flag Detect setting screen is displayed when the surround back speaker(s) is/are set to "Large" or "Small" at the "Speaker
Configuration" screen.
• The surround back speaker(s) can also be turned on and off with the 6.1/7.1 SURROUND button on the main unit. (See page 45.)
2O
To Next Page
Loading...
Need help?
General
