Denon AVR-982

Setthedistancebetweenthe
centerspeakerand listening
position.
Thedistancechangesinunitsof1
foot(0.1meters)eachtimethe
buttonispressed.Selectthevalue
closesttothemeasureddistance.
Delay Time
Default [_4
Front L 112ft_
Front R 12ft
[ Center 12ft I
_r f2tf
Example:When the distanceis setto 12 feet
forthe centerspeaker
Delay Time
10 ft
10 ft
[_|:ll[eId:._lll=:]llllE41_[€l [-I_1
'_ if "Yes" is selected for "Default", the settings are automatically reset
to the default values.
Please note that the difference of distance for every speaker should be 15
ft {4.5 m) or less. If you set an invalid distance, a CAUTION notice, such as
screen right will appear. In this case, please relocate the blinking speaker{s)
so that its distance is no larger than the value shown in highlighted line.
Default [_4
Front L 12ft
Front R 12ft
Center lft
BlII,,'?_ITI _1.1ill
Enter the setting.
The System Setup Menu reappears.
The AVR-2802/982 automatically sets the optimum surround delay time for the listening room.
NOTE:
• If the distance unit is changed after the delay time is set, the settings are reset to the factory default values (see page 16).
• Use this setting to adjust so that the ptayback level between the different channels is equal.
• From the listening position, listen to the test tones produced from the speakers to adjust the level.
• The level can also be adjusted directly from the remote control unit. (For details, see page 42.)
At the System Setup Menu select "Channel Level".
System Setup Menu
Speaker Configuration
SB CH Auto Flag Detect
Delay Time
rChannel Level
Digital In Assignment
On Screen Display
Auto Tuner Presets
2
Switch to the Channel Level screen.
Channel Level
_Test Tone Mode
Test Tone Start [_<
Level Clear [_<
Select "Test Tone Mode".
22