• DENON components can be operated by setting the preset memory for CDR or MD. Operation is not possible for some models, however.
in this case use the learning function (see page 32) to store the remote control signals.
• For instructions on clearing the presettJngs stored in the preset memory, see page 35.
1
2
Set the slide switch to "AUDIO".
AUDIO
Set the slide switch to "CDR/MD.
TAPE CDPdMD
cD li MULT_I
_ f f'_
V_ VCR
Keep the POWER button pressed in
when performing steps 3 and 4 /
3
Holding in the POWER button, press the
button for the components you want to
set.
The LEARNED/TX LED flashes.
_@0_
1
_._1_ _1
Combinations of Personal System Codes
"CDR/MD"
c? c?
_. (DIRECT) (STEREO) (EXT IN)
/POWERIENON'CD DENONCDRBDENONMD
1111111
3
3
2
Preset codes set upon shipment from the factory
• DENON and other makes of components can be operated by setting the preset memory for your make of video component. Operation is not
possible for some models, however, in this case use the learning function (see page 32) to store the remote control signals.
• For instructions on clearing the presettings stored in the preset memory, see page 35.
1
Set the slide switch to "VIDEO".
AUDIO
AVPdAVC VIDEO
Set the slide switch to the component to
be registered (DVD, VDP, VCR or TV}.
TAPE CDR/MD
CD _li MULTI
VDP VCR
Keep the POWER button pressed in
\
when performing steps 3 and 4 /
Holding in the POWER button, press the
button for the corresponding manufacturer
in block A. Flashes
(Refe_
The LEARNED/TX LED flashes.
4
Next, while holding the POWER button,
press the button for the code in block B.
(Refer to Table 1.) The operation is
completed when the button is released and
the LEARNED/TX LED lights.
To continue registering other components,
repeat steps 2 to 4.
3
x/
_%o o o
3,4
4
2
• This remote control unit can be used to operate components of other manufacturers without using the learning function by registering the
manufacturer of the component as shown on Table 1.
To Next Page
Loading...
Need help?
General
