Select the play mode.
Press the SURROUND MODE button, then turn the SELECT
knob.
Example: Stereo
SURROUND SELECT
MODE ST£REO
(Main unit) {Remote cont ro_ unit)
TO select the surround mode while adjusting the surround
parameters, channel volume or tone control, press the surround
mode button then operate the selector.
SURROUND
MODE
Input mode display
• in the AUTO mode
INPUT
_UT9 PCM DTS
o o o
/i \
• in the DIGITAL PCM mode
_N_UT
AUTO \p¢_ eTS
o o o
/i \
• in the DIGITAL DTS mode
_N_UT
AUTO PCM @TS_
o o o
/i _
• in the ANALOG mode
INPUT
AUTO pCM DTS
o o o
One of these Hghts, depending on the
input slgna_
{Mainunit)
Start playback on the selected component.
• For operating instructions, refer to the component's
manual.
Adjust the volume.
tO_ MAS ERV0 UME
The volume level is {Main unit) {Remote control unit)
displayed on the master
volume level display
The volume can be adjusted within the range of -70 to 0 to 18 dB,
in steps of 1 dB. However, when the channel level is set as
described on page 22 or pages 42 and 43, if the volume for any
channel is set at +1 dB or greater, the volume cannot be adjusted
up to 18 dB. {In this case the maximum volume adjustment range
is "18 dB -- {Maximum value of channel level)".}
Input mode when playing DTS sources
• Noise will be output if DTS compatible CDs or LDs are played in the
"ANALOG" or "PCM" mode.
When playing DTS-compatible sources, be sure to connect the
source component to the digital input jacks (OPTICAL/COAXIAL}
and set the input mode to "DTS'.
Input signal display
• DOLBY DIGITAL
SIGN&L
O
• DTS
• PCM
0 0
,_ The _ indicator lights when digital signals are being input
properly. If the _ indicator does not light, check whether
the digital input component setup {page 24) and connections are
correct and whether the component's power is turned on.
NOTE:
• The _ indicator will light when playing CD-ROMs
containing data other than audio signals, but no sound will be
heard.
To Next Page
Loading...
Need help?
General
