Denon AVR-X3200W

3.6.4. Clearing the Protection History
There are two ways to clear the protection history.
(a) Activate Protection History Display Mode. Press the "
STATUS
" button to display the protection history. Press and
hold the "
DIMMER
" button for 3 seconds.
FLD
P R T : D C
Press and hold the "
DIMMER
" button for 3 seconds.
FLD
P R T : C L E A R
The above message is displayed and the protection history is cleared.
FLD
N O P R O T E C T
(b) Initialize this unit. (See "Initializing This Unit" page 11)
b
Use the method in 3.5.4.(a) if you do not want to erase your settings from this unit.
Warning Displays by POWER LED
If the power is turned off while a protection is being detected, the POWER LED ashes in red to warn you depending on
the protection status as follows.
(a) ASO/DC protection: Flashes at 0.5-second intervals (0.25 seconds lit, 0.25 seconds unlit)
(b) THERMAL (A/E/F) protection: Flashes at 2-second intervals (1 seconds lit, 1 seconds unlit)
(c) CURRENT protection: Flashes at 4-second intervals (2 seconds lit, 2 seconds unlit)
3.7. 232C Standby Clear Mode
3.7.1. Actions
Switches from 232C standby mode to normal standby mode.
3.7.2. Starting up
While holding down buttons "
ZONE2 SOURCE
", "
DIMMER
" and "
STATUS
" simultaneously, press the power button to
turn on the power.
Select the "3.RS232C RESET" using the "
TUNER PRESET CH +/-
" button, then press the "
STATUS
" button then to con-
rm.
FLD
3 . R S 2 3 2 C R E S E T
s
58