3.9. TUNER STEP mode
(E2 / E3 only)
3.9.1. Actions
This is a special mode for enabling reception STEP of the ANALOG TUNER to be changed.
3.9.2. Starting up
While holding down buttons "
ZONE2 SOURCE
", "
DIMMER
" and "
STATUS
" simultaneously, press the power button to
turn on the power.
Select the "
5. TUNER FRQ SET
" using the "
TUNER PRESET CH +/-
" button, then press the "
STATUS
" button to conî™°rm.
3.9.3. Displays
Start up this unit in TUNER STEP mode, select the desired option using the "
TUNER PRESET CH +/-
" button, then enter
using the "
STATUS
" button.
The following information is displayed in the following order.
(a) AM9 kHz / FM50 kHz is selected
FLD
< A M 9 / F M 5 0 >
"
TUNER PRESET CH+
" "
TUNER PRESET CH-
"
(b) AM10 kHz / FM200 kHz is selected
FLD
< A M 1 0 / F M 2 0 0 >
"
STATUS
"
(c) Press the power button to turn off the power.
(d) Press the power button to turn on the power.
60
To Next Page
Loading...
