EasyManuals Logo

Denon AVR-X3200W User Manual

Denon AVR-X3200W
325 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #238 background imageLoading...
Page #238 background image
o
Sound is interrupted or noise occurs
Symptom Cause / Solution Page
During playback from the
Internet radio or USB
memory device, sound is
occasionally interrupted.
0
When the transfer speed of the USB memory device is slow, sound may occasionally be interrupted.
0
The network communication speed is slow or the radio station is busy.
When making a call on
iPhone, noise occurs in
audio output on this unit.
0
When making a call, keep a distance of 0.7 ft/20 cm or longer between iPhone and this unit.
Noise often occurs in
FM/AM broadcasting.
0
Change the antenna orientation or position. 59
0
Separate the AM loop antenna from the unit.
0
Use an outdoor antenna. 59
0
Separate the antenna from other connection cables. 59
The sounds appear to be
distorted.
0
Lower the volume. 68
0
Set “Off” to the ECO Mode. When “On” or “Auto” is in the ECO Mode, the audio may by distorted when
the playback volume is high.
216
Sound cuts out when using
Wi-Fi connection.
0
If nearby devices cause playback to cut out due to electronic interference, switch to a wired LAN
connection.
61
0
Particularly when you play back large music files, depending on your wireless LAN environment, the
playback sound may be interrupted. In this case, make the wired LAN connection.
208
Contents Connections Playback Settings Tips Appendix
238
Front panel Display Rear panel Remote Index

Table of Contents

Other manuals for Denon AVR-X3200W

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Denon AVR-X3200W and is the answer not in the manual?

Denon AVR-X3200W Specifications

General IconGeneral
Receiver typeSurround
Input sensitivity200 mV
Audio output channels7.2 channels
Signal-to-Noise Ratio (SNR)100 dB
Power output per channel (1KHz@6 Ohm)180 W
Power output per channel (20-20KHz@8 Ohm)105 W
HDMI in8
Audio (L/R) in5
Composite video in3
USB ports quantity1
Component video (YPbPr/YCbCr) in2
12V triggerYes
Speakers connectivity type-
AM band range522 - 1611 kHz
FM band range87.5 - 108 MHz
Supported radio bandsAM, FM
Internet radio services supportedvTuner
Optical drive includedNo
DisplayLCD
Product colorBlack
Audio decodersDTS-HD Master Audio, Dolby Surround, Dolby TrueHD
AC input voltage230 V
AC input frequency50 Hz
Power consumption (typical)650 W
Weight and Dimensions IconWeight and Dimensions
Depth388 mm
Width434 mm
Height167 mm
Weight11300 g

Related product manuals