Denon AVR-X4000

1.4. Version display on the Setup Menu
Use the following procedure to display the rmware version.
(1) Press the
"SETUP" button on the remote control.
(2) Select "General-Information-Firmware".
A version with 12 digits is displayed as shown in the following image.
AVR-X4000 GUI Image
The displayed 12 digits are derived from each device version as shown below
The 2nd digit from the right for Main
The 1st digit from the right for Main
The 2nd digit from the right for Sub
The 1st digit from the right for Sub
Main 0 0 3 8 Info display 1 2 1 0 - 8 3 8 2 - 6 1 7 3
Sub 6 6 1 0 0 0 2 8
DSP 8 4 0 2 The 1st digit from the right for DSP1
8 5 0 1 The 1st digit from the right for DSP2
A.PLD 2 4 0 1 The 1st digit from the right for A.PLD
GUI 6 5 1 1 0 0 1 6 The 1st digit from the right for GUI
DM860 FBL 0 9 0 3 1 1 The 2nd digit from the right for GUI
DM860 SBL B
z z z z z z z z
1 7 1 8
DM860 IMG I
z z z z z z z z
0 4 3 7 The 1st digit from the right for IMG
The 2nd digit from the right for IMG
b
This rmware version No. (xxxx-xxxx-xxxx-xxxx) is included in the service contact document.
These 12 digits are also included in the document.
1210 - 8382 - 6173
24