Denon DHT-1312XP - Page 17

17
[ If you can't get a "Connected" message. ]
(7-a) Click the “Connect” button. If connection is not good, then you can see the “Don't Connect” message.
Please conrm the following
(i) Check the connection of the AV receiver and PC. (Refer to "1.2. Connection of the AV receiver" )
(ii) Check the selection of the RS-232C port number of PC.
(ii) Refer to "3. Notice: ". (page 27 )
(7-b) If Ram/Flash le selection screen is active, after you Click "Resend" button.
Connection is good, go to next step.