Getting Started Installation Connections Settings Operation Specifications
ENGLISH
If a problem should arise, first check the following:
1. Are the connections correct?
2. Is the set being operated as described in the owner’s manual?
3. Are the other components operating properly?
If this unit does not operate properly, check the items listed in the table below. Should the problem persist, there may be a malfunction.
In this case, disconnect the power immediately and contact your store of purchase.
Troubleshooting
Symptom Cause Countermeasure Page
When the power is turned on,
the power indicator does not light
and no sound is produced.
• The power cord’s plug is not fully plugged in. • Check the insertion of the power cord plug
and connect securely.
8
The power indicator lights but
no sound is produced.
• The position of the input selection button is
inappropriate.
• The volume is turned all the way down.
• The mute mode is set.
• Analog connection cables are not securely
connected.
• No digital signal is being input.
• Switch to the correct function (input).
• Press [VOLUME+] on the remote control
unit.
• Cancel the mute mode.
• Connect securely.
• Properly select a digital signal input source.
10
10
10
7, 8
10
No DTS sound isproduced. • DVD player’s audio output setting isn’t set to
bit stream.
• DVD player is not DTS-compatible.
• DHT-FS5’s input setting is set to analog.
• Use the DVD player’s default settings.
• Use a DTS-compatible player.
• Use a digital input.
–
–
10
No sound is produced from
subwoofer.
• Subwoofer’s output is not connected. • Connect securely. 8
Remote control unit does not
operate.
• The batteries are flat.
• The remote control unit is too far away.
• There is an obstacle between the main unit
and the remote control unit.
• The batteries are inserted in the wrong
direction.
• Replace with new batteries.
• Operate from closer to the main unit.
• Remove the obstacle.
• Insert the batteries in the proper direction.
2
2
2
2
Other Functions
Analog Input Sensitivity Setting
Press and hold in [ANALOG (An)] for at least 3 seconds.
“Hi ( ) ” is shown on the display for about 5 seconds, and
the input sensitivity is set to +6 dB.
b When [ANALOG (An)] is pressed again and held in for at least 3
seconds, ”Lo ( ) “ is shown on the display for about 5 seconds,
and the input sensitivity is set to 0 dB.
b This mode is set to “Lo” upon purchase.
If the sound is distorted when the input sensitivity is set to “Hi”, set
it back to “Lo”.
Press and hold in [ON/STANDBY] for at least 3 seconds.
“Off ( ) ” is shown on the display for about 5 seconds, and the
auto power off function is canceled.
b When [ANALOG (An)] is pressed again for at least 3 seconds, “On
( ) ” is shown on the display for about 5 seconds, and the auto
power off function is set.
b This mode is set to “On” upon purchase.
Auto Power Off
The standby mode is set if there is no input for 10
minutes.
Depending on the device connected, the auto power off function may
not work. In this case, set the auto power off function to "Off" and turn
the DHT-FS5’s power off manually.
Press and hold in [SETUP] for at least 3 seconds.
“RESET ( ) ” is shown on the display for about 5 seconds, and the
settings are restored to as they were upon purchase.
Resetting the Microprocessor
This restores the various settings to as they were upon
purchase.
Other Functions Troubleshooting
To Next Page
Loading...
Need help?
General
Weight and Dimensions
