Denon DNP-730AE - Firmware Update Procedure; Updating by DPMS

24
FIRMWARE UPDATE PROCEDURE
1. Updating by DPMS
Download the latest rmware from the internet and update the rmware.
1.1. Network Connection
(1) System requirements
• A broadband internet connection
• Modem
• Router
• Ethernet cable (CAT-5 or greater recommended)
(2) Settings
1.2. Checkandupdatethermware
Check whether new rmware is available. It is also possible to check approximately how long the update will take.
(1) Press POWER button to turn on power.
(2) Press SOURCE button to display menu.
• Press CURSOR
d
/
f
buttons select to General. Press the ENTER.
• Press CURSOR
d
/
f
buttons select to Firmware Update. Press the ENTER.
• Press CURSOR
d
/
f
buttons select to UPDATE.
• Press CURSOR
d
/
f
buttons select to CHECK For UPDATE.
(3) Press the ENTER button.
• If the latest rmware has been already installed, press the SOURCE button to close the Update menu.
(4) Press ENTER button. Select YES, then press ENTER button.
(5) To start the update.
(6) When rewriting is completed, this unit restarts itself automatically.
(7) Press the POWER button to turn off the power.
(8) Hold down the POWER button for at least 3 seconds while pressing the CURSOR
d
button.
This unit sets the version display mode.
Please conrm the rmware version.
(9) Check MAC Address.
Setup → Network → Network Info → MAC Address
(10)The back panel of the unit, MAC Address seals, please change new one.
Please conrm the MAC Address display is corresponding to the seal.
(11)Hold down buttons "SOURCE" button and "CURSOR
d
" button at the same time and press the "POWER" button to
turn on the power. (
Initialization for the factory
)
--- Precautions for Updates ---
• The environment and settings must allow connection to broadband Internet for updates.
• Never turn off the power before an update is completed.
• It takes around 1 hour to complete the update.
Once an update is started, normal operations cannot be performed until it is completed.
The menu settings of this unit may be initialized.
Take note of your settings beforehand and recongure them after the update.
R L
AUDIO
OUT
OUT
DIGITAL AUDIO
OPTICAL
WPS
IR
WI-FI
CONNECT
OUT
IR
CONTROL
iOS
WI-FI
CONNECT
TO DENON
DCD OR PMA
NETWORK
Modem
Internet
Computer
LAN port/
Ethernet
connector
ETHERNET
connector
Router
To WAN port
To LAN port
To LAN port