Denon DRA-385RD - Disassembly Instructions; Disassembling the Top Cover; Disassembling the Front Panel; Disassembling the Rear Panel

ENGLISH
4. inputting characters 3. Press the SHIFT/PTY button® to move the cursor to the next place.
Any characters can be input (up to 8 characters). (The cursor flashes at the second place).
The input characters can be stored at the preset channels.
Operation
1. Press the RDS button ® four times.
(The cursor flashes at the first place.) Flashes
4. Repeat steps 2 and 3 above to input up to 8 characters.
Flashes PIP LY of
A CJL L H Lf
2. Usethe TUNING UP or DOWN button® to select the character Flashes
for
the
first
place.
:
F
F
(The
selected
character
flashes.)
5.
The
characters
are
set
five
seconds
after
the
input
procedure
is
finished. The input characters can be stored in the memory.
To keep the input characters, be sure to store them in a channel
memory.
Flashes 6. Clearing characters
1. Recall the character you want to clear.
2. Press the RDS button ® 4 times until the character at the first
place flashes.
. Then press the SHIFT/PTY button ® for at least 2 seconds. The
current character will then be cleared.
wo
Table of characters
The characters are input in the order shown to the right. Use the
TUNING buttons @ to select the desired characters.
M
ABLDEFGHIUKLMNUOPORRSTUYVWXYZ
hes tS6 Teor Nem < =f = SPACE
Using the RDS functions (for FM only)
1. RDS search 2. PTY Search
Use this to automatically search and stop at stations offering RDS Use this to automatically search and stop at stations broadcasting the
services. specified programme type (PTY).
Operation Operation
1. Press the RDS button ® once. 1. Press the RDS button ® twice.
RIS
SEARCH
Par
sere
2. Press the PRESET UP or DOWN button ®. 2. Use the SHIFT/PTY button @ to select the programme type.
(Searching begins.)
TANI TILOMELIT TIN!
aes INFURMAT ION
RDS
Ti [~
Ro SENG
ae eee 3. Press the PRESET UP or DOWN button ®.
(Searching begins.)
3. Searching begins again if the PRESET UP or DOWN button®
Flashes
is pressed while the RDS indicator is flashing.
Flashes
LS Flashes
4. If no other RDS station is found when all the frequencies are
searched, “NO RDS’ is displayed.
10