Denon DRA-385RD - Measurement Setup Diagrams; FM Section Measurement Configuration

ENGLISH
12
PLAYBACK USING THE REMOTE CONTROL
The accessory RC-174 remote control unit is used to control the RECEIVER from a distance.
(1) Inserting the dry cell batteries
1. Remove the rear cover on the remote control unit.
<A
2. _ Inserttwo size “AA” (R6) dry cell batteries as shown in the
diagram on the battery supply unit.
3. Replace the rear cover.
(2) Directions for use
Note on Operation
Notes on Use of the Batteries
The remote control unit uses size “AA” (R6) dry cell batteries.
The batteries will need to be replaced approximately once a
year. This will depend upon how often the remote control is
used.
If, in less than a year from the time new batteries were inserted,
the remote control fails to operate the receiver from a near-by
position, it is time to replace the batteries.
Insert the batteries properly, following the diagram on the
remote control battery supply unit, and making sure to align the
plus and minus sides of each battery.
Batteries are prone to damage and leakage. Therefore:
¢ Donot combine new batteries with used ones.
¢ Do not combine different types of batteries.
© Do not jumper the opposite poles of the batteries, expose
them to heat or break them open, or put them into open fire.
When the remote control is not to be used for a long period of
time, remove the batteries from the unit.
If the batteries have leaked, remove any battery fluid from the
inside of the battery supply unit by wiping it out thoroughly and
insert new batteries.
Operate the remote control unit while pointing it towards the
remote control sensor on the receiver as shown in the diagram
left.
The remote control unit can be used at distances up to about
8 meters in a straight line from the receiver. This distance will
decrease if there are obstructions blocking the infra-red light
transmission or if the remote control unit is not directed straight
at the receiver.
* Donot press the operating buttons.on the receiver and the remote control unit at the same time. This will cause misoperation.
© Operation of the remote control unit will become less effective or erratic if the infrared remote control sensor on the receiver is exposed to strong
light or if there are obstructions between the remote control unit and the sensor.
* incase you operate your VCR, TV or other components by remote contro!, do not operate buttons on two different remote control units at the
same time. This will cause misoperation.
|
: