Denon DRA-385RD - System Block Diagrams; Overall Block and Level Diagram

ENGLISH
Besides being able to operate the DRA-385RD receiver with this remote control unit, you can also operate
a DENON cassette deck and CD player from this handy full-system remote control unit.
Remote Control Section
Full-system Remote Control Unit
The full-system remote control unit operates ail major functions of the receiver such as function switching, volume control, and preset station
selection. But that’s not all! The same control pad can also control the major functions of a DENON CD player and cassette deck to create a
remarkably ergonomic and versatile DENON system with all the quality sound reproduction that the devoted audiophile expects.
Remote Control Unit RC-174 supplied with DRA-385RD
[DECK |
PLAY button
PLAY (REV) button
STOP button
REWIND button
FF button
Refer to the
operating inst-
ructions of your
DENON tape
deck.
A/B DECK
SELECT button
4 PLAY (REV)
Hi PAUSE
A/B W-DECK
PANEL button
The display switches between the frequency,
manual characters, station name,
programme type and time each time this
button is pressed. Station names,
programme types and the time are only
displayed when receiving RDS stations.
The following may appear on the display for some
stations, but this is not a malfunction:
“NO PTY”: This is an RDS broadcast, but
the programme type (PTY) is not
being broadcast.
“NO PS”: An RDS broadcast is being
received, butthe PS (Programme
Service name or station name)
is notbeing received due to weak
signals, etc.
“NO TIME DATA”: Thisis displayed when the station
currently tuned in is not
broadcasting time data, and may
be displayed for one minute after
the poweristurned on even when
the station currently tuned in is
broadcasting time data.
(The PANEL button only operates when the function
is set to the TUNER mode.)
RCVR
CD_ PHONO
eae fe |
Co) 4
| mcrae 4
POWER button
PLAY button
STOP button
Reverse Track
Search button
Forward Track
Search button
PAUSE button
REPEAT REPEAT button
RANDOM _| RANDOM button
DISC SKIP | DISC SKIP button
a8 PAUSE
INPUT SELECTOR buttons
VOLUME buttons (4%)
PRESET buttons (aw)
Operate the monitor of the
tape deck with the TAPE MONITOR
button.
e The RC-174 Remote Control Unit can control CD players and cassette decks made by DENON.
© Note the operation may not be possible for some models.
e Buttons are conveniently separated into groups, each group controlling one specific component. The groups are RECEIVER; CD and DECK.
For details on operating other components, refer to the instruction manuals for the CD player and/or cassette deck.
CAUTION:
© Ifthe power is turned off with the remote control unit, the receiver is switched to the power stand-by state. If you are to be absent foralong
period of time, be sure to turn the power off using the POWER switch on the receiver.
e Apart of 1st digit of fluorescent display light while the receiver is in the power stand-by state.
« You may experience erratic operation of the remote control unit if itis operated in fluorescent light and direct sunlight, in particular if this light
strikes the remote control sensor on the receiver. However, this is nota malfunction, and if this should happen, protect the sensor against such
light.
13