Denon DRA-385RD - Troubleshooting; Reception Problems; Audio Playback Issues

Preset (Preset station buttons)
These buttons are used for storing stations or recalling stations which
havebeen preset. Using the SHIFT/PTY button youcan preseta total
of 40 FM or AM stations into preset channels.
Once a radio has been memorized, the same station can later be
tuned in instantly simply by recailing the corresponding preset
channel with PRESET UP or DOWN button.
DISPLAY
@
@
RDS indicator
This lights when receiving RDS broadcasts, and flashes during the
RDS search operation.
EON indicator
This lights when receiving EON information.
TA indicator
This lights when receiving traffic announcements.
TP indicator
This flashes during the TP search operation and lights when TP
stations are tuned in.
PTY indicator
This flashes during the PTY (Programme Type) search operation.
TUNED indicator
This lights when a station is properly tuned in.
STEREO indicator
This lights when receiving stereo broadcasts. It remains off when
receiving AM broadcasts.
USING THE VARIOUS FUNCTIONS
1. Using the auto preset memory function
This function automatically stores the FM stations which can be
received in the area in which the set is being used in the preset
memory. Use this function so that the RDS functions can be used
more effectively. Also note that the channel memories can be
changed at will even after the preset stations have been stored
with this function.
Operation
1. Connect the FM antenna and setit so that FM stations can be
received.
2. Press the POWER button to turn on the power while holding in
the MEMORY button ®.
3. Searching begins automatically, and stations are stored in the
preset memory in order, beginning from channel A1. (The
operation automatically stops once 40 stations have been set
inthe memory.)
ENGLISH
MEMORY (Memory button)
This switch is used to store the desired radio station to a memory.
SHIFT / PTY button
Use this button to select the memory blocks, A (1 to 8), B (1 to 8),
C (1 to 8), D (1 to 8) or E (1 to 8).
For PTY search, use this button to select the program type.
When writing station names, use this button to set the writing
position.
AUTO indicator
This indicates the tuning mode. It lights in the auto mode and
remains off in the manual mode.
MEMO indicator
This indicator lights for approximately 10 seconds when the
MEMORY button has been pressed anda station can be stored on
a PRESET CHANNEL button.
This flashes continuously during the auto memory operation.
CH indicator
This lights when the preset channel number and shift mode (A, B,
C, D or E) are displayed.
TAPE indicator
The TAPE indicator lights when the TAPE source is selected with
the tape selector buttons.
Multi function display
This displays the frequency, station name, program type, etc.
2. Storing new stations at the preset channels
The reception frequency, RDS service information, Tuning
mode and input characters can be stored at the different channel
memories.
When this operation is performed, the station already stored in
that channel memory using the auto preset memory function is
cleared.
Operation
1. Pressthe MEMORY button @. (The MEMO indicatorflashes.)
2. Use the SHIFT/PTY button @ to select the block, A to E.
3. Use the PRESET UP or DOWN button @ to select the
channel at which the station is to be stored.
4. Press the MEMORY button® again to store the stationin the
memory.
3. Recalling preset channels
Use the following operation to recall preset channels:
Operation
1. Use the SHIFT/PTY button ® to select the block, A to E.
2. Usethe PRESET UP or DOWN button® to recall the station
stored in the memory.
If the PRESET UP or DOWN buttons are pressed without
pressing the SHIFT/PTY button, the stations are recalled
in the order A1 to A8, B1 to B8, and so on through E8.