Denon DRA-385RD - Advanced Functions; Inputting RDS Characters; RDS Search Modes; EON TA and Emergency Alarm

SPEAKER CONNECTION
Confirm polarity (+,-) and left and right channels (L, R). Connect
the speaker pairs to the SPEAKER terminals A or B on the back
panel. Connections must be made with power cord disconnected.
Preparing the cord
1. Peel of the sheath. 2. Twist the wires.
| Peel. Twist.
Q
a) es (a...) a
ANTENNA INSTALLATION
e FM ANTENNA
The supplied indoor FM antenna can be used inside wooden
houses for receiving local FM stations and other strong FM
signals. Stretch out the end of the antenna and mount the
antenna on the wail or ceiling where optimum reception is
achieved. An indoor FM antenna may not consistently ensure
stable reception, due to environment changes. In such cases,
the indoor FM antenna should only be used temporarily until an
outdoor FM antenna has been installed.
When connecting an outdoor FM antenna, the use of 75 ohm
coaxial cable (3C-2V, 6C-2V) is strongly recommended.
© AM ANTENNA
Attach the supplied AM loop antenna even when using an
outdoor AM antenna.
Connect the leads to the AM and GND terminals.
Also use the AM terminals for connecting an outdoor AM
antenna (when making such a connection do not disconnect
the AM loop antenna).
Adjust the loop antenna to obtain optimum reception. Where
broadcast stations are distant and only weak signals are
received or where signals are blocked, it is best to install an
outdoor AM antenna.
Notes on Connection
e Donotplug the power cord into the AC wall outlet until all
connections have been completed.
e Make sure channels are correctly connected. Connect
Left channeis to Left channeis and Right channels to
Right channels. Follow the color markings of plugs and
terminals to make sure mistakes are not made.
Connect all pin-plugs securely, pushing them completely
into the jacks incomplete connections will cause noise
generation.
Binding the connection cables to power cords, or running
such cables close to power supply transformers will
cause humming or noise, and should thus be avoided.
ENGLISH
Connecting the front speaker terminals
1. Loosen by turning counterclockwise.
2. Insert the cord and tighten by turning clockwise.
er
Assembling the Loop Antenna
¢ Remove the tie fastening the loop antenna’s lead
and connect the lead to the antenna terminals.
Notes:
Do not connect two FM antennas simultaneously.
Even ifan external AM antennais used, do not disconnect
the AM loop antenna.
Make sure AM loop antenna lead terminals do not touch
metal parts of the panel.
CAUTION
Protective Circuit
This set is equipped with a high speed protective circuit.
This circuit protects the internal circuitry from damage due
to large currents flowing when the speaker jacks are not
completely connected or when an output is generated by
a short circuit.
This protective circuit's operation cuts off the output to the
speakers. In such a case, be sure to turn the power to the
set off and check the connections to the speakers. Then
turn the power on again. After muting for several seconds,
the set will operate normally.
|
|
|
;