Denon DRA-385RD - Panel Control Functions; Front Panel Control Descriptions; Tuning and Input Selection; Advanced Functions

ENGLISH
CONNECTIONS
VCR
DIRECTION OF (Video Cassette ————
SNS SPEAKER (
L all SPEAKER (B)
75 ohm
coaxial cable 0
FM Indoor antenna
GND
|
REC
14)
7)
‘
i
e\
a
YN
—
tet
a
Pees
Ol
©
CZ
oe
TAPE
DECK
-_
TURNTABLE
REAR PANEL
@ FM ANT (FM antenna terminals)
75-ohm coaxial cable can be connected to this terminal. For
antenna connecting procedure, see ANTENNA INSTALLATION.
cD
The output cord of the CD player is connected here.
VIDEO
2] GND (Grounding terminal) A VIDEO, such as a VCR or Video Disc may be connected here.
The grounding wire of the turntable is connected here.
* Hum or noise may be generated if the grounding wire is not
connected.
TAPE
Tape decks can be connected for full use including playing or copying.
@ AMANT(AM antenna terminais)
Connect the attached AM loop antenna. (Refer to page 7 for
connections).
Connect to this terminal when a medium wave outdoor antenna is
used,
SPEAKER SYSTEMS (Speaker terminals)
Two pairs of speakers A and B can be connected to these terminals.
AC OUTLET (AC power outlet)
This AC outlet is controlled by the power switch.
4]
PHONO
(Phono
input
terminals)
(Except
units
are
sold
in
U.K.
and
Eire)
The output cord of the turntable is connected here.
Since the input sensitivity of “PHONO” is extremely high, do not AC Inlet
use the unit without the input pin cord. If used without this cord, the Connect the included AC cord here.
speakers may generate hum.