20
Convenient functions
Setting the optimizing filter for the SC-F109
speaker system (sold separately)
The receiver’s speaker output signal properties are set to be optimal
for the SC-F109.
1
Press SYSTEM SETUP.
2
Use ui to select “SPK
OPTIMISE”, then press the
ENTER or p.
3
Use ui to select “ON”, then press the ENTER or p.
The setting is entered.
Auto standby
When this unit is in the stop state and there is no input signal and
operation for 30 minutes, it automatically enters the standby mode.
For the input source “ANALOG IN:1” and “ANALOG IN:2” only, when
no operation is performed for eight hours, this unit automatically
enters the standby mode.
•The default setting for the Auto Standby mode is “ON”.
1
Press SYSTEM SETUP.
2
Use ui to select “AUTO
STANDBY”, then press ENTER
or p.
3
Use ui to select “ON”, then press ENTER or p.
The setting is entered.
NOTE
In the following situations, the Auto standby function does not operate.
•When the source is “TUNER”.
Last function memory
This stores the settings as they were directly before the standby
mode was set.
When the power is turned back on, the settings are restored to as
they were directly before the standby mode was set.
To Next Page
Loading...
