The following transition occurs during connection to the network. Refer to "QSG".
Not connected
Press "Connect" but-
ton.
Connection estab-
lished between HEOS
and smartphone
Connected to the
network
When network
connection setup is
complete
Amber : Solid Green : Blinking Green : Solid Blue : Blinking Blue : Solid
Time-out
Red : Solid (7sec.)
The following transition occurs when the "
Bluetooth
" button is pressed.
Bluetooth Pairing enabled Pairing successful
Green : Blinking Twice
Repeated
Blue : Blinking Once
Repeated
Pairing failed
Red : Solid (7sec.)
8. When connecting to network (Setup Assistant)
9. Bluetooth
The following transition occurs when this unit switches to standby.
Network
connected
Quick Start mode
No access over
20 min.
Blue : Solid
Blue : Solid
(Dimmer)
Access from app
Not connected Not connected Deep Standby
No access over
20 min.
60 min. later.
Amber : Solid Amber : Solid LED : Off
Access from app Button operation
Connected to the
network
The indicators are lit as shown below when the "
Volume
" button and "
Mute
" button are pressed.
"Volume" button "Mute" button
Blue : Fast Blinking Blue : Solid
The following transition occurs when "Submit Diagnostics" is performed from the HEOS app.
Operations in HEOS app : Settings - Advanced - Submit Diagnostics
Network connected Sending diagnostic data Diagnostic data sent
Blue : Solid Purple : Blinking Blue : Solid
Time out in HEOS app
Red : Blinking Once
10. Standby
11. Volume button and Mute button
12. Submit Diagnostics
Status LED Connect in Status LED
54
Caution in
servicing
Electrical Mechanical Repair Information Updating
To Next Page
Loading...
