Configuration
Restore to Factory
Default
Click Reset button to restore the HEOS
Extend to its factory default settings. This is
the same as using pressing the button on the
top panel with a paper clip.
Backup Settings Click Save to save the current configured
settings to your PC.
Restore Settings Restore settings that have been previously
backed up, click Browse, select the file, and
click Upload.
System Log
Displays information about the operation of the system over time.
Restart
Used to remotely reboot the wireless network extender. Settings are not
changed. To perform the restart, click on the Restart button. The restart will
be completed when the LED Power light stops blinking.
2 Tools
Time Server
Time Setup Select what method to use for time
synchronization.
Time Zone Select the time zone for the location of the
Extend.
NTP Time Server Select the name of the NTP time server from
which to retrieve the correct time over the
Internet.
Daylight Saving Enable or disable Daylight Savings time and
specifies when it is active.
Ping
Address to Ping Enter the address you want to send a ping
test to.
Ping Frequency Select how many times to perform the ping
test.
Iperf
Used to perform an iperf server.
To Next Page
Loading...
