o
Auto scanning broadcast stations
Connect the antenna beforehand.
1
Press SETUP during DAB reception.
2
Use ui to select “TUNER SETUP”, then press ENTER.
3
Use ui to select “DAB AUTO SCAN”, then press
ENTER.
4
Press ENTER.
This unit searches for receivable DAB stations.
o
Switching the reception information for the
currently tuned in DAB station
1
Press INFO during DAB reception.
Dynamic Label Segment:
Text data included in the broadcast is
scrolled.
Station Name: The service station name is displayed.
Program Type:
The category of the tuned in station is
displayed.
Ensemble Name: The ensemble name is displayed.
Frequency: The frequency is displayed.
Signal Quality:
The reception signal intensity is
displayed (0 to 8).
0
If the reception signal intensity is 5 or
greater, the program can be received
without noise.
Audio Information:
The mode of the currently tuned in station
and its bit rate are displayed.
Contents Connections Playback Settings Tips Appendix
40
Front panel Display Rear panel
Remote
Index
To Next Page
Loading...
