4. CD Test mode
4.1.Operation
In "
STANDBY
" status, press and hold the "
CURSOR
o
" and "
VOLUME
d
" buttons along with the power operation but-
ton to turn on the power.
"
CD Test Mode
" displayed for 5 seconds.
CD TEST MODE display(Disk loading)
To exit this mode, unplug the power cord.
4.2. Before starting the test
Open the tray and set the disc.
Even if the disc is, the tray must let OPEN → CLOSE.
4.3. Servo check
Press "
1
/
3
" button. Execute the following steps.
z
Press and hold the "
1
/
3
" button for at least one second to proceed directly to the step in which the sub code from
t
is read. Press the "
INPUT
" button to return to the "
0 CD TEST MODE
" display.
"
1
/
3
"
q
LD ON
"
1
/
3
"
w
FOCUS ON
"
1
/
3
"
e
CLV ON
"
1
/
3
"
26
To Next Page
Loading...
