Denon RCD-N9

PROCEDURE AFTER REPLACING THE MICROPROCESSOR, ETC.
The procedure after replacing the u-COM (microprocessor), ash ROM, etc. is as follows.
  





(MAIN) IC28 R5F56108VNFP B
-
CN66
CN67
CY920 MODULE ASSY B
SOFTWARE: SYSTEM
Be sure to replace the NFC module at the same
time.
Procedure after Replacement
 The software has been written. The software is not written at the time of replacement.
 The software has been written. The software may need to be rewritten by version updates. Check the version.
 The software has not been written. The software needs to be written after replacement.
See "" for information on writing the software.
 The software has been written. Be sure to rewrite with the latest software for your service region.
See "" for information on writing the software.
FIRMWARE UPDATE PROCEDURE
1. Updating by USB
The latest rmware can be downloaded to a USB memory for updates.
1.1. Connecting to the USB Memory
(1) Preparation
• USB format : Prepare a USB memory formatted in FAT16 or FAT32.
• Do not run the USB memory through a hub.
• Do not connect a computer to the USB port of this unit using a USB cable.
• Do not use an extension cable when connecting the USB unit.
1.2. Unzip Download File
Unzip the downloaded le on your computer.
 
You can nd "
rmwares
" folder after unzipped.
Copy that folder to USB ash drive.
You have to put "
rmwares
" folder on root directly on USB ash drive(memory).
copy to USB flash drive
31