If an error occurs during uploading
If some error occurs during uploading, the BHT beeps three times and shows one of the following
screens:
To retry the uploading operation, press the 1 and ENT keys; to abort it, press the 2 and ENT keys.
Problem
The file you attempted to upload is damaged.
Solution
To upload the damaged file as is, press the 1 key.
Problem
Uploading has failed.
Solution
To retry uploading, press the 1 key.
To return to the SYSTEM MENU, press the 2 key. Check the interface
port, communications parameters, and communications protocol in
the SET SYSTEM menu or perform the communications test in the
TEST menu. (Refer to Section 2.5.3, [4.5] and [5.7].)
It is also necessary to check the communications parameters setup o
To Next Page
Loading...
