On the SET SYSTEM menu, selecting the "5: COMMUNICATION"
calls up the screen shown at left.
[1] OPTICAL: Switches to the communications parameters
setting screen for the IrDA interface.
[2] CONNECTOR: Switches to the communications parameters
setting screen for the direct-connec
interface.
[3] COM PORT: Switches to the interface port setting screen.
[4] PROTOCOL TYPE: Switches to the communications protocol
type setting screen.
Select a desired screen by using the numerical keys or F5 and F6
keys, and then press the ENT key.
To return to the SET SYSTEM menu, press the C key.
Setting the communications parameters for the IrDA interface
On the SET COMMUNICATION menu, select "1: OPTICAL" to call up
the screen shown at left.
[1] PARAMETER: Switches to the communications parameters
setting screen.
[2] PROTOCOL: Switches to the communications protocol option
screen.
Select a desired screen by using the numerical keys or F5 and F6
keys, and then press the ENT key.
To return to the SET COMMUNICATION menu, press the C key.
60
To Next Page
Loading...
