Denso BHT-904B - Page 82

68
BHT-904B/BHT-914B
 “2: DECODE LEVEL”: Decode level
Set the decode level (barcode reading tolerance level).
Press [◄] to decrease the setting value and [►] to increase the setting value.
we
n the other hand, increasing the level decreases the barcode reading efficiency, but w
g.
mber of barcode digits to be read for ITF

 “5: CODABAR”: Minimum number of barcode digits to be read for Codabar
the setting value and [►] to increase the setting value.
STF entry range: 1 to 20 Default: 3
Codabar entry range: 3 to 20 Default: 4
he frequency of missing digits when reading or incorrectly
des.
On the other hand, setting a large number will decrease the possibility of such errors.
Sets the type of the codemark.
Codem
ark
system specified for DENSO
Codemark system complies with the AIM US “Guidelines on Symbology Identifiers”
Decode level
entry range: 1 to 9
Default: 4
Decreasing the level increases the barcode reading efficiency, ho ver, the BHT may incorrectly read
ill decrease the
low-quality (split or stained) barcodes.
O
possibility of incorrect readin
 “3: ITF”: Minimum nu
“4: STF”: Minimum number of barcode digits to be read for STF
Sets the minimum number of barcode digits to be read.
Press [◄] to decrease
ITF entry range: 2 to 20 Default: 4
Setting a small number of digits increases t
reading depending on how barcodes are read or the quality of barco
 “6: CODEMARK”: Setting for the codemark type
ORIGINAL
AIM